Navigate
Wasp Helpdesk
  • Register

  • or
  • Login
    Need a password reminder?
or
Contact Us
  • Get in touch

    Send us an email

  • Start a chat session

  • Knowledgebase Read help articles
  • News News & updates
  • Contact Us We are here to help
  • Training View our options
  • Product Sunsets Non-Supported Products
Barcode System Consult
Barcode Printer Consult
Barcode Label Consult
  • Portal
  • Knowledgebase
  • Hardware
  • Printers
  • WPL612: how to mount a 1-inch core roll of labels
Subscribe Download PDF

WPL612: how to mount a 1-inch core roll of labels

Scott Leonard
2025-01-07
in Printers

The supply spindle in the WPL612 is 1-3/8 inches wide, preventing mounting of a label roll that has a 1-inch core. How to allow this?


You'll need a #2 Phillips-head screwdriver.

1. Remove the screw from the front of the spindle.

2. Remove the back screw, from the right side. The nut on the left is welded to the shroud, so it won't get lost.

3. Slide the shroud piece down to remove it.

4. To prevent loss of the screws, if you like, screw the back (long) screw into the shroud, and the front (short) screw into the spindle.


This allows mounting of smaller-core rolls (down to about 3/4 inch) onto the supply spindle.


WPL612-supply-spindle-shroud.jpg

WPL612-supply-spindle-bare.jpg

Rate the quality of this page

This page was helpful :) :( This page was not helpful

18 of 28 people found this page helpful


Quick Jump
  • Wasp Helpdesk
  • Knowledgebase
  • News
  • Contact Us
Top
Helpdesk software provided by Deskpro