Go to the User's Reference Manual.
Page 2. Scan Enter Setup
Page 2. Scan Memory Mode -> Enable
Page 1. Scan Update
Scan the barcodes you want to store.
Now open Windows Notepad (or data entry application of your choice). Notepad is suggested for testing purposes.
To get the codes from the scanner to the active application, do the:
Page 2. Scan Enter Setup
Page 2. Scan Send Data
The information stored on the scanner will be sent over to the active cursor (wherever the cursor is blinking) at this time. Depending on the amount of data that you have stored, this may take a while.
Page 1. Scan Update.
To disable the Memory Mode do the following:
Page 2. Scan Enter Setup
Page 2. Scan Memory Mode -> Disable
Page 1. Scan Update
To clear what is in memory, do the following:
Page 2. Scan Enter Setup
Page 2. Scan Clear
Page 2. Scan Confirm
Page 1. Scan Update
This article applies to the WWS 800 & WWS 850 scanner.
Page 2. Scan Enter Setup
Page 2. Scan Memory Mode -> Enable
Page 1. Scan Update
Scan the barcodes you want to store.
Now open Windows Notepad (or data entry application of your choice). Notepad is suggested for testing purposes.
To get the codes from the scanner to the active application, do the:
Page 2. Scan Enter Setup
Page 2. Scan Send Data
The information stored on the scanner will be sent over to the active cursor (wherever the cursor is blinking) at this time. Depending on the amount of data that you have stored, this may take a while.
Page 1. Scan Update.
To disable the Memory Mode do the following:
Page 2. Scan Enter Setup
Page 2. Scan Memory Mode -> Disable
Page 1. Scan Update
To clear what is in memory, do the following:
Page 2. Scan Enter Setup
Page 2. Scan Clear
Page 2. Scan Confirm
Page 1. Scan Update
This article applies to the WWS 800 & WWS 850 scanner.