The List Setting configuration barcodes are on printed page 3 (PDF page 4) of the Reference Guide (manual with configuration barcodes).
Procedure for outputting this information:
- Launch a program such as Notepad or MS Word to receive the information from the scanner.
- Scan Enter Setup (bottom of even-numbered pages).
- Scan the Page x configuration barcode. The data is sent immediately. Do not click out of your program from step 1, until all the data is transmitted.
- Scan Update (bottom of odd-numbered pages). If this step is omitted, the scanner is still in Setup mode.
An example list page is below. S/N is the serial number; Ver is the firmware version.
Parameter Listing (Page 1) S/N : AG1002220 Ver:5.52 =============================================================================== Interface Parameters Interface Type : Keyboard Wedge (PCAT - US Keyboard) Capital Lock OFF, Alphabets Case Sensitive, ALT Composing Disable, Send Digits Using AlphaNumeric Key Pad, Digit Position - Default, KBD Layout - Default, Shift/Capital Lock - Default, Inter-Character Delay 0 ms RF Auto-Off : 10 min Power Save Mode : Enable Memory Scanner : Disable Memory Data Delay : No Transmit Buffer : Disable Buzzer Parameters Frequency : 4 KHz Buzzer Disabled : No Scanner Parameters Scan Mode : Laser Mode Scanner Time-out : 10 Sec Negative Barcode : Disable Reading Redundancy : No Re-read Delay : 400 ms